To obtain access to full text of journal and articles you must register!
- Article name
- AUTOMATION OF DESIGNING A CUTTING TOOL SETUP CARD USING THE APPLICATION PROGRAM INTERFACE NX OPEN
- Authors
- Kondusova V. B., , valyosha@list.ru, Federal State Budgetary Educational Institution of Higher Education "Orenburg State University", Orenburg, Russia
Kondusov D. V., , kdimka@list.ru, Federal State Budgetary Educational Institution of Higher Education "Orenburg State University", Orenburg, Russia
Sergeev A. I., , alexandr_sergeew@mail.ru, Orenburg State University, Orenburg, Russia
Tsyrkaev A. A., , andrei_cirkaew@mail.ru, JSC "КumАPE", Kumertau, Republic of Bashkortostan, Russia
- Keywords
- CAM-system / NX Open / control program / numerical program control / setup card / cutting tool
- Year
- 2021 Issue 2 Pages 30 - 34
- Code EDN
- Code DOI
- 10.52190/2073-2597_2021_2_30
- Abstract
- The problem of automation of the transfer of relevant information about the cutting tool to the setup card is considered. To solve the problem, a dynamic library was developed using the NX Open application programming interface. As a result, a reduction in the design time of cutting tool setup cards was achieved and data transfer errors between the subsystem for generating control programs and the subsystem for designing technological processes were eliminated.
- Text
- To obtain access to full text of journal and articles you must register!
- Buy
