To obtain access to full text of journal and articles you must register!
- Article name
- Investigation of the influence of electrical discharge machining modes on operational properties of products made of granulated heat-resistant nickel alloy VV751P
- Authors
- ABLYAZ T. R., , lowrider11-13-11@mail.ru, Perm National Research Polytechnic University, Perm, Russia
SHLYKOV E. S., , Kruspert@mail.ru, Perm National Research Polytechnic University, Perm, Russia
BLOKHIN V. B., , warkk98@mail.ru, Perm National Research Polytechnic University, Perm, Russia
OSINNIKOV I. V., , ilyuhaosinnikov@bk.ru, Perm National Research Polytechnic University, Perm, Russia
KHAIRULIN V. T., , khairulin-vt@mail.ru, Perm National Research Polytechnic University, Perm, Russia
MURATOV K. R., , karimur_80@mail.ru, Perm National Research Polytechnic University, Perm, Russia
- Keywords
- heat-resistant nickel alloy / wire-cut electrical discharge machining / surface layer / residual stresses / cyclic durability / low cycle fatigue
- Year
- 2024 Issue 2 Pages 22 - 27
- Code EDN
- AMQQJM
- Code DOI
- 10.52190/2073-2562_2024_2_22
- Abstract
- The work investigated the influence of wire-cut electrical discharge machining (WEDM) modes on the performance properties of products made from heat-resistant nickel alloy VV751P. New data were obtained on changes in the microstructure of the transitional altered layer and the magnitude of residual stresses after WEDM of products made of heat-resistant nickel alloy VV751P. Cyclic tests of these samples for low-cycle fatigue were carried out. The values at which destruction of samples made of heat-resistant nickel alloy VV751P materials occur have been established.
- Text
- BUY for read the full text of article
- Buy
- 500.00 rub
