To obtain access to full text of journal and articles you must register!
- Article name
- CHOOSING THE OPTIMAL MEANS OF CONVERTING THREE-DIMENSIONAL MODELS TO GCODE FOR SUBSEQUENT 3D-PRINTING
- Authors
- Pitelinsky K. V., , yekadath@gmail.com, Federal State Autonomous Educational Institution of Higher Education "Moscow Polytechnic University", Moscow, Russia
Makovey S. O., , intele577tuver@gmail.com, Moscow Polytechnic University, Moscow, Russia
Kodzaev N. P., , kol.kodzaev@yandex.ru, Federal State Autonomous Educational Institution of Higher Education "Moscow Polytechnic University", Moscow, Russia
- Keywords
- 3D-model / Saaty method / 3D-printing / slicers / optimization / 3D-printer / multi-material printing
- Year
- 2025 Issue 1 Pages 25 - 33
- Code EDN
- OBMVKK
- Code DOI
- 10.52190/2073-2597_2025_1_25
- Abstract
- It is shown that when using additive technologies, the choice of the optimal means of converting three dimensional models into GCODE for subsequent 3D- printing will depend on the tasks solved by the user, the type of printer and the printing requirements. The results of the choice based on the method of T. Saaty are presented.
- Text
- BUY for read the full text of article
- Buy
- 500.00 rub
